| Specifications |
| Holder Type: |
OCXO-14T5.0 5.0V (Voltage code is " 5.0 " ) |
| Supply Voltage range: |
+5.0V ±0.2V |
| Frequency Range: |
1.250 MHz to 100.000 MHz |
| Initial Calibration Tolerance: |
±0.5ppm max., Vcon = +2.5V |
| Frequency Stability (FS): |
|
| (FS) Operating Temperature Range: |
0°C ~ 60°C, typical ±0.2 (ppm), avaiilable ± 0.025 (ppm)
-20°C ~ 70°C, typical ±0.3 (ppm), avaiilable ± 0.050 (ppm)
-40°C ~ 85°C, typical ±0.5 (ppm), avaiilable ± 0.100 (ppm) |
| (FS) Voltage Change: |
(± 0.2V) < ± 0.1ppm |
| (FS) Warm up time (+25°C): |
3 minutes (max.) |
| (FS) Aging: |
±0.7 ppm first year, < 4.0ppm over 10 years |
| (FS) Load Change: |
? ± 0.01ppm, for ± 5% load condition change |
| Voltage Control on pin 1 (EFC): |
Electronic Frequency Tuning
|
| (EFC) Freq. Deviation Range: |
± 4.0ppm (min.), Reterence to fo at +25°C |
| (EFC) Control Voltage Range: |
(+5.0V) 0.0 to 5.0V |
| (EFC) Transfer Function: |
Positive: Increasing control voltage increases output frequency |
| (EFC) Input Impedance: |
47 k Ohm (min.) |
| (EFC) Linearity: |
± 10 % (max.) |
| Power Dissipation (at 25°C): |
steady-state : 1.5 W (max.) , turn-on: 2.5W (max.) |
| Output: |
Load (Fan out) : 10LS
Output Logic: High (Voh) +4.5V (min), Low (Vol) +0.4V (max.)
Duty Cycle (at 50% Vcc) : 50% ± 10%
Rice and Fall Time (20%to 80%) : 7ns (max.) (20% to 80% of waveform) |
| Output Phase Noise (10.0 MHz): |
-70dBc/Hz @ 1Hz, -100dBc/Hz @ 10Hz, -130dBc/Hz @ 100Hz,
-140dBc/Hz @ 1kHz, -145dBc/Hz @ 10kHz |
