| Specifications - Product No. G166670000DWCUPB90BB |
| Holder Type: |
CXO7050PK2.5; 2.5V(Voltage code is "2.5"); Tri-State on pad 1 |
| Frequency: |
166.670000 MHz |
| Frequency Stability at 25°C: |
± 50.0 ppm |
| Operating Temperature Range: |
± 50.0 ppm over -10°C to +70°C (incusive of 25°C tolerance,
±10% input voltage variation, load change, aging, shock and vibration ) |
| Storage Temperature: |
-55°C to +150°C |
| Power Supply Voltage (Vdd): |
+ 2.5V D.C. ± 5% |
| Maximum Supply Current (15pF load): |
30.0 mA typ. |
| Output Swing: |
595 mV min; 750 mV typical; 930 mV max. |
| Output Logic Levels: |
High "1" Voh Vdd-1.025V min., Vdd-0.95 V typical;
Vdd-0.88V max. Condition: RL= 50 Ohm to (Vdd-2.0V)
Low "0" VoL Vdd-1.810V min., Vdd-1.70 V typical;
Vdd-1.62V max. Condition: RL= 50 Ohm to (Vdd-2.0V) |
| Output Symmetry (Duty Cycle): |
50% ± 5%max. measured at 50% waveform |
| Load: |
RL=50 Ohm into (Vdd-2.0V) or
Thevenin equivalent (terminating resistors required on all outputs). |
| Rise/Fall Time: |
0.3ns typical, 0.5ns max. @ 20% to 80% of PECL wave form |
| Start Up Time: |
3 ms typical; 10 ms max. |
| OE Function Pin 1: |
-Enable: When 70% min. of VDD to Enable Output.
Enable time: 10ms
-Disable: When 30% max. of VDD to Disable Output.
Disable current : 10 µA, Disable time : 0,2 µs (max.) |
| Phase Jitter (12 kHz to 20 MHz): |
200 fs typical |
| Phase Noise (125 MHz): |
-50dBc/Hz @ 10Hz, -82dBc/Hz @ 100Hz, -116dBc/Hz @ 1kHz
-138dBc/Hz @ 10kHz, -144dBc/Hz @ 100kHz, -149dBc/Hz @ 1MHz |
| Aging: |
< ±3ppm max. for the first year |
| Reflow Condition: |
260°C max for 10 sec. |
